placing order when line is touched not working

im having difficulties with my code, in backtesting it does not place 2 pending orders when it reaches the middle white line on screen.
code for the middle white line:
BarCount = NormalizeDouble((iATR(NULL,1440 ,200,0)/MarketInfo(Symbol(),MODE_POINT))/10,0);
double value = High[iHighest(NULL,0,MODE_HIGH,BarCount,1)] - Low[iLowest(NULL,0,MODE_LOW,BarCount,1)];
double sixth = value/6;
MiddleWhiteLine = NormalizeDouble(Low[iLowest(NULL,0,MODE_LOW,BarCount,1)]+sixth+sixth+sixth, Digits);

the variables for 5 digit broker i use:
//++++ These are adjusted for 5 digit brokers.
double pips2points, // slippage 3 pips 3=points 30=points
        pips2dbl; // Stoploss 15 pips 0.0015 0.00150
int Digits.pips; // DoubleToStr(dbl/pips2dbl, Digits.pips)

in my EA init i have:
if (Digits == 5 || Digits == 3)
   { // Adjust for five (5) digit brokers.
               pips2dbl = Point*10; pips2points = 10; Digits.pips = 1;
   } else { pips2dbl = Point; pips2points = 1; Digits.pips = 0; }

For placing the pending orders i use:
//CENTERLINE ORDER
   if (Ask == MiddleWhiteLine) {
     entryw1 = TopGreenLine;
     TPw1 = TopGoldLine;
     SLw1 = MiddleWhiteLine;
     entryw2 = BottomGreenLine;
     TPw2 = BottomGoldLine;
     SLw2 = MiddleWhiteLine;
     Print('Pending GSPE Orders placed');
     OrderSend(Symbol(),OP_BUYSTOP,lots,entryw1,100,SLw1,TPw1,NULL,MagicNumber,0,Blue);
     Sleep(1000);
     OrderSend(Symbol(),OP_SELLSTOP,lots,entryw2,100,SLw2,TPw2,NULL,MagicNumber,0,Red);
   }
   //END CENTERLINE ORDER

Hopefully someone can tell me why it's not working, and what i should change.

It is virtually impossible to compare 2 doubles in MQL4, so your case of Ask==MiddleWhiteLine will just about never be true, even though to you, visually it may 'appear' to be true.

Try giving it a bit of slack, so perhaps check if the MiddleWhiteLine falls between the spread eg :-

if(Ask>=MiddleWhiteLine && Bid<=MiddleWhiteLine)...............etc

Also the sleep command between your orders is superfluous and will cause quote problems. Why is it there? I would just delete it and if you really must leave it there, then do a RefreshRates() before the second order.

Another thing, if you are working with only the currenct chart symbol only then you do not need marketinfo to get the point value......just use Point. It makes the code shorter and easier to read. I have not really examined the code but I think that your BarCount should use Point * 10 and not divided by 10.

Hope it helps

In fact looking at it, the whole BarCount line just does not make any sense at all. You are calculating the daily ATR value and then using that as a number of bars that you need to count back to get the highest and lowest values in a timeseries array?

Your BarCount used in iHighest(iLowest) must be an integer??